They are discs that due to the quality and concentration of diamond offer durability and fast and great penetration, some are specific for a type of material and others are very versatile and allow cutting abrasive and non-abrasive materials, as well as steel and cast iron pipes.

Developed for cutting construction materials in general except abrasive materials, they have a good performance with high penetration and durability as in the case of the super ventilated Turbo.

This Constools range of discs, highly appreciated by tile setters, is intended for cutting ceramic and porcelanic tiles. They are very good quality discs that stand out for their fine and precise cut. They are presented in the continuous crown version or the extra fine Turbo version.

It is a range of discs specially designed to cut abrasive materials widely used in the construction sector such as: Concrete block, reinforced concrete, fresh concrete, old concrete, sandstone, silicon terrazzo, low-alumina refractory, facing brick, concrete joist. These materials, although not excessively hard, cause significant friction and wear during cutting, cause why is needed to use this perfectly adapted range of discs.

For this type of material, Constools has two ranges of discs specially adapted: Electroplated discs from 115 to 230mm for dry cutting and segmented discs from 300 to 500mm. for cutting with water. Consult for other diameters.

The purpose of these dishes is to rough grind and dry polish marble, granite, terrazzo, epoxy resin, etc.

These semi-rigid discs are particularly suited for roughing and polishing concrete.