Avoid lippage during the laying of ceramic tiles in both floor and wall tiles. For tiles up to 30x30 cm. and always with back buttering. Impact removal system.

Great performance and efficiency thanks to the Vacuum Brazed technology for welding the diamond to the crown.

Perfect holes in porcelanic tiles up to 20 mm thick and in many other materials such as klinker, tiles, granites and marbles, slate, glazed cast-iron tub, composite materials of polyester, fiberglass and similars.

Use with a minimum 500W drill or grinder.

It is recommended for prolonging the life of the diamond drill bits, moisten.

Make a moderate pressure so that the drill bit makes the cut, an excessive pressure will overheat the diamond and lose the durability.

It is recommended, for the prolongation of the useful life of the diamond drill bit, a good refrigeration by turning in a vacuum or wetting the diamond zone every 45-60 seconds.

It is an essential objective for Constools to care about the safety of ceramic tile installers. For this reason, we offer a range of personal protective equipment designed for the ceramic tiler, in order to always improve working conditions.

Ergonomics, safety, reliability and high quality are the qualities we pursue our safety equipment.

Tungsten carbide crowns are still a useful and necessary tool for drilling many materials that due to their characteristics do not require the use of diamond crowns. They perfectly perforate: bricks, tiles and vaults of fired clay, slate, marble, tiles, fiber cement, plasterboard, foam concrete, etc.

The Constools range of mallets are made of premium rubber and are intended to ensure the correct settlement and leveling of ceramic tiles as well as their perfect adhesion with glue cement.

Our range of Constools pots is presented with three different weights: 750gr., 1000gr., 1250gr. With wooden handle or fiber handle, the heads are forged steel.

The point chisels and chisels are made of steel and the cutting area is forged and rectified. They are available in various lengths: 200mm., 250mm, 300mm., 350mm. 400mm

With this range of plungers Constools provides solutions to the problems of clogging and plugging of drains and pipes.

Constools offers an extensive range of spacers and wedges to supply to the different joint thicknesses when laying tiles. Both cross-shaped and T-shaped facilitate regularity and perfect alignment of the joints. They come in bags of 250, 500 and 1000 units.

Constools pliers are essential tools and a great help for the professional in cutting ceramic tiles. They are made of forged steel and one of them the cutting area is tungsten carbide offering a very precise cut. The ergonomic handles are covered in red rubber.

Leaving a perfectly finished and clean tile is the culmination of a work done in the rules of a professional. To facilitate this task Constools offers a wide range of floats and sponges of different thicknesses and densities

The range of spades is completed with two models: tip and square, handled type hope or ring and made of hardened steel, highly resistant and tenacious to wear and tear.

Tools specially dedicated to handling and laying large format porcelain sheets.
Designed to cover and solve the peculiarities of these materials.

The purpose of this range of products is to obtain a perfect finish for the laying of ceramic and other tiles. This range is made up of cleaning products which facilitate the removal of stains from cement or mortar and also a product for the polishing and crystallization of stone, marble or terrazzo floors.